Hello. Here I have the outline of DTC ecu connector CBR600RR 07/08. I can help to make the pinout Connection
12v- pin black connector 4-5
Gnd- pin gray connector 1-4
k-line- pin black connector 30
Flash v- pin gray connector 19
But do not read anything
I am trying to put way FP. But I do not have a lot of time and am a bit lost.
Setting MCU in bootmode? I am working on a similar ECU, so we can probably solve it by comparing notes. Mine is opened on the bottom for the TPīs so far. Would say i am almost sure by some measuring that i have successfully set it in bootmode.FP, MOD0, and Reset i would say are verified so far on the Test Pads. Have a pretty good idea about rx/tx too. But have not cut to MCU yet.See picture, a bit easier to solder TPīs. And much less risc of shorting between small MCU pins when soldering.Send me and e-mail, itīs on my profile. So we can do some quick comparing and testing.