I purchased and recently installed the 08 Gen II Hayabusa nitrous harness and installed it on an 07-08 GSXR 1000. I see noted in the installation, the wire to be tapped into off the nitrous harness to the stock harness near the ecu connector is pin 37 ( O/Bl) wire. This wire is the (DMS 1) Driver Mode Selector. I searched the pin out on the 07-08 GSXR1000 and the (DSM 1) pin is pin 63 which is also an (O/Bl) wire as noted in the diagram provided. I would think it would be safe to assume this is the wire I would tap into in order to use the toggle switch off of the nitrous harness to activate the nitrous. I will also be installing the gen II busa .bin into the 07-08 GSXR 1000 ecu to allow these features. Any input or what to look for or expect prior to finalizing the installation of both the .bin and the nitrous harness is appreciated. If nothing else, I'll attach the pin out of the 07-08 GSXR 1000 ecu in the event it may be useful to someone searching this option in the future. Thanks in advance.
07-08 GSXR1000 pin out