06 750

Carry · Senior Member

RE: 06 750

Twice · Senior Member

Does ecu editor interface only works with Ecu Editor? Or FTD olso?
Does the FTD interface also work in Ecu Editor? (i know our files dont, yet.) :)
Anf if so, whats the difference?

I have to compare schematics and see what does what.
So i will order parts this week and hope i got em before the weekend.

Tried to gnereate an .xml from the .bin i pulled. If i got this right, starting address for lookup table is address 40000 (262144).
Looks right and looked up the start address as you described in other thread Ridge. The .xml uotputs data and fills all adresses.

But the generator did not find more than 180 maps total, 89-2D and 31-3D. Is that right? Or does the bin2xml stop before the end
of the code in 7054 becouse of bigger memory? BIN2XML maybe ends reading before the file is done?
Since alla other addresses i have seens has been 28000-2C000 instead of 4000.

RidgeRacer · Guru

the xml converter is not very "intelligent". The maps need to be sequentially listed or it stops. Sometimes you have to run it as two batches and paste them together. 31-3D definitely sounds on the short side.

Twice · Senior Member

Ridge, your program seem to be more than intelligent enough. I think i ****ed up again.
After two days of barbeque and beer and now hangover i tried again, i think something got wrong when
transfering files to and from an XP 32-bit laptop to run the BIN2XML and then copy back to mine.

Now your very nice program generates 180 maps still, but 89 2D maps & 91 3D maps.
And now the readings go all the way down to the adress where the last filler starts, address 5D2C0 (381632).
So now it looks like the reading go through all the code for the maps? Can about 180 total maps be right still?

Carry, how does the map count for the 600 def file you got looks like? And are start and end addresses similar?

Carry · Senior Member

Well to be honest i cant remembar;) But def file is quite ready, we used 600 defs for that with changed starting adress. Bin files of 750 and 600 are almost the same and 600 defs worked with my bike well so far:)

Carry · Senior Member

Definitions are ready and doing its job:) So this one is done;) Still looking for 750 US and 600 EU bins...

Twice · Senior Member

Wonderful! Looked good! Hopefully i get the ecu connectors and cables this week, i will test it out as soon as i got the flash interface done.

Rudi · Member

Carry wrote:
Definitions are ready and doing its job:) So this one is done;) Still looking for 750 US and 600 EU bins...

Hi Carry

May I have a copy of the bins and exl files for the 750 euro model? the 32920 02H00?

jkwool · Guru

I am not sure if you are aware but the Woolich Racing Tuned software has the ability to flash the 2006/2007 GSX-R 750 32920-02H00 and 32920-02H10, you can download the software from the following link, there is a very modest fee for the bin file of US$100 and all funds are reinvested in purchasing more ecu's to expand the model range of the software.

http://www.woolichracing.com/tuned/

Carry · Senior Member

Just follow Justin:)